Detaylı Arama

İptal
Bulunan: 91 Adet 0.001 sn
- Eklemek veya çıkarmak istediğiniz kriterleriniz için 'Dahil' / 'Hariç' seçeneğini kullanabilirsiniz. Sorgu satırları birbirine 'VE' bağlacı ile bağlıdır.
- İptal tuşuna basarak normal aramaya dönebilirsiniz.
Filtreler
Filtreler
Bulunan: 91 Adet 0.001 sn
Ambargo Durumu [1]
Tam Metin [2]
Yazar [90]
Yayın Türü [3]
Yayın Dili [2]
Dergi Adı [67]
Konu Başlıkları [90]

Electrokinetic removal of manganese from river sediment

Genç, Ayten | Chase, George | Foos, Annabelle

Manganese was removed from naturally polluted river sediment by applying an electrokinetic remediation technique. The sediment was alkaline and had 20% clay, which was mainly illite. The electrokinetic remediation experiments were performed by controlling pHs in the electrode cells and reverse electroosmotic flows were observed, i.e., water moved from cathode towards anode. Manganese accumulated in areas closer to cathode, however, other metals, such as copper, zinc and lead were mostly observed in the middle section of the sediment. As a result of reverse electroosmotic flow, the removal effi ...Daha fazlası

Erişime Açık

Novel Enzymatic Rhodium Modified Poly(styrene-g-oleic amide) Film Electrode for Hydrogen Peroxide Detection

Kılıç, Muhammet Samet | Korkut, Şeyda | Hazer, Baki

Newly synthesized poly(styrene-g-oleic amide) was coated onto a rhodium nanoparticle modified glassy carbon (GC) surface for the fabrication of horseradish peroxidase based biosensor used for hydrogen peroxide detection. The rhodium modifed electrode presented ten times higher signal than unmodified electrode even at low elecrtroactive enzyme quantity by enhancing the electron transfer rate at the applied potential of -0.65 V. The biosensor designed by under the optimized rhodium electrodeposition time exhibited a fast response less than 5 s, an excellent operational stability with a relative ...Daha fazlası

Comparison of electrodialysis and reverse electrodialysis processes in the removal of Cu(II) from dilute solutions

Altın, Süreyya | Öztekin, Elif | Altın, Ahmet

Electrodialysis (ED) and electrodialysis reversal (EDR) processes have been often used for separation of ions in dilute solutions. In this study, the performance of ED and EDR processes has been examined in the removal of copper from the dilute solutions. First, applied voltage, initial concentration, flow rate, type of electrolyte and the effect of concentration were determined for both processes. Then, separation efficiency, current efficiency, energy requirement and material flux of the processes were calculated, and the performances of the processes were compared. The separation efficiency ...Daha fazlası

Erişime Açık

Novel graphene-modified poly(styrene-b-isoprene-b-styrene) enzymatic fuel cell with operation in plant leaves

Korkut, Şeyda | Kılıç, Muhammet Samet | Uzunçar, Sinan | Hazer, Baki

A carboxylated poly(styrene-b-isoprene-b-styrene) triblock copolymer was synthesized for the construction of an enzymatic fuel cell. Glucose oxidase and bilirubin oxidase were chemically immobilized via the carboxylated functional groups of the polymer. The enzymatic fuel cell working electrodes were modified with graphene to accelerate the electron transfer rate of the system. Essential design and operational parameters were carefully optimized for improving the power of the enzymatic fuel cell. A power density of 20 µW cm-2 with only 4 µg of immobilized bilirubin oxidase was generated from 3 ...Daha fazlası

Impacts of sludge retention time on membrane fouling in thermophilic MBR

İnce, Mine | Topaloğlu, Alikemal

The aim of this study is to investigate the membrane fouling in a thermophilic membrane bioreactor (TMBR) operated different sludge retention times (SRTs). For this purpose, TMBR was operated at four different SRTs (10, 30, 60 and 100 days). Specific cake resistance (?), cake resistance, gel resistance, total resistance, MFI (modified fouling index) and FDR (flux decrease ratio) were calculated for all SRTs. It was observed that flux in the membrane increases with rising SRT although the sludge concentrations in the TMBR increased. The steady state flux was found to be 31.78; 34.70; 39.60 and ...Daha fazlası

Destabilization and treatment of emulsified oils in wastewaters by electrocoagulation

Genç, Ayten | Bakırcı, Büşra

In this study, the optimum operating conditions for the treatment of emulsified oils by electrocoagulation were determined depending on droplet stability analysis. Zeta potential measurements were used as the indication of oil droplet charges. In addition, the effects of pH and ionic conductivity on the droplet sizes and surface charges were investigated. The studied emulsified oil droplet sizes were more sensitive to changes in pH rather than salt concentration. The droplets became larger and unstable in alkaline conditions. As the initial pH of wastewaters increased, the oil removal efficien ...Daha fazlası

Sorption of acid dyes from aqueous solution by using non-ground ash and slag

Genç, Ayten | Oğuz, Aşkın

The sorption of two acid dyes (Acid Yellow 99 and Acid Red 183) into locally available industrial waste materials, namely, Granulated Blast Furnace Slag (GBFS) and Furnace Bottom Ash (FBA), has been investigated by performing batch equilibrium experiments with pH, ionic conductivity, initial dye concentration and temperature as variables. The kinetic sorption data indicated that the sorption capacity of GBFS for these dyes was almost zero. On the other hand, the color removal efficiency for FBA could reach 50% depending on the initial dye concentration. It was also found that the kinetics of s ...Daha fazlası

Transport of Lead (Pb2+) Ions through silty-clayey soils under acidic conditions

Genç, Ayten | Ulupınar, Elif

This study aimed to identify effects of pH on the transport of Pb2+ ions through a saturated silty-clayey soil layer by using advection-dispersion equation (ADE). The predictive accuracy of the solution of ADE depends on the proper determination of the retardation by adsorption and, therefore, the adsorption mechanism of lead onto silty-clayey soil was investigated first by performing batch equilibrium experiments. These results showed that the sorption mechanism of lead onto silty-clayey soil depended on pH and could be best described by the Langmuir isotherm. Based on the results of the sequ ...Daha fazlası

An alternative type of photoelectro-Fenton process for the treatment of landfill leachate

Altın, Ahmet

An alternative type of photoelectro-Fenton (PEF) process has been proposed to remove COD, color and phosphate from the landfill leachates. The process was improved by combining the different type of electro-Fenton (EF) process with UV irradiation. The efficiency of the process and settling characteristics of waste sludge produced from the process were investigated by changing some operating parameters such as initial pH, H2O2 and current. In addition, the proposed process was compared with other treatment processes such as electro-coagulation (EC), electro-Fenton and UV/H2O2 in terms of treatm ...Daha fazlası

Erişime Açık

Prediction of the bottom ash formed in a coal-fired power plant using artificial neural networks

Bekat, Tuğçe | Erdoğan, Muharrem | İnal, Fikret | Genç, Ayten

The amount of bottom ash formed in a pulverized coal-fired power plant was predicted by artificial neural network modeling using one-year operating data of the plant and the properties of the coals processed. The model output was defined as the ratio of amount of bottom ash produced to amount of coal burned (Bottom ash/Coal burned). The input parameters were the moisture contents, ash contents and lower heating values of the coals. The total 653 data were divided into two groups for the training (90% of the data) and the testing (10% of the data) of the network. A three-layer, feed-forward typ ...Daha fazlası

Effects of coal properties on the production rate of combustion solid residue

Durgun D. | Genç, Ayten

The production rates of furnace bottom ash in a pulverized coal-fired power plant were monitored for a two-year period and its variations with respect to coal properties were analyzed. The power plant was originally designed to fire the coal sludge generated from a washing process; however, the coal sludge and its mixture with low-rank bituminous coal have been started to be used as the main fuel with time. The results of the hardgrove grindability measurements have shown that the grinding properties of sludge or its mixtures could not be predicted based on proximate analysis (moisture, ash, c ...Daha fazlası

Erişime Açık

Industrial noise and its effects on humans

Atmaca, Eyüp | Peker, İ. | Altın, Ahmet

The problem of noise in the industries around Sivas has been examined in this study; and noise measurement and survey studies have been carried out at concrete traverse, cement, iron and steel and textile factories located in this region. A questionnaire was completed by 256 workers during this study in order to determine the physical, physiological, and psycho-social impacts of the noise on humans and to specify what kind of measurements have been taken both by the employers and workers for protection from the effects of noise. It has been specified, during the surveys, that the noise levels ...Daha fazlası

6698 sayılı Kişisel Verilerin Korunması Kanunu kapsamında yükümlülüklerimiz ve çerez politikamız hakkında bilgi sahibi olmak için alttaki bağlantıyı kullanabilirsiniz.
Tamam

creativecommons
Bu site altında yer alan tüm kaynaklar Creative Commons Alıntı-GayriTicari-Türetilemez 4.0 Uluslararası Lisansı ile lisanslanmıştır.
Platforms